Heatvape RDA Coiler / Coil Winding Tool Kit with 5 Coil Diameters



Heatvape RDA Coiler / Coil Winding Tool Kit with 5 Coil Diameters

 

Product Introduction

Heatvape RDA Coiler Winding Tool Kit with 5 Coil Diameters is a smart and intelligent design from Heat Vape, this coiler comes with a brand new DIY tool for experienced users with the capacity of better rebuilding coils and vaping experience.

This kit offers five diameters sizes for coil: 3.5mm  3.2mm  2.5mm  1.6mm  1.0mm.

 

Parameters

Length: 88mm

Diameter: 11mm

 

 

 

The product comes with

• 1 x Heatvape Coiler
• 1 x Operation Guide

Simple packing. Customary Packing from the factory,the packing is subject to change without notice.

 

Please assemble the coiler as the picture when not in use.

1. Part 1 contains 5 different items (a)

2. Part 2 contains 5 different items (b)

 

 

 

How to use:

 

Before Winding
1. Assemble 1 pc of (a) to the other side of Part 1
2. Assemble 1 pc of corresponding (b) to Part 3
3. And then combine Part 1 and Part 3 together

Notice: There are 5 different diameters in total that matches (a) with (b)

 

 

How to build your coil

1. Insert the wire coil through Hole (c)

2. Place the wire under Bolt (d)

3. Unroll Bolt (e) slightly and then tighten it back under Bolt (e)

4. Wind the wire carefully making sure it does not overlap

 

 

Take off the coil and cut the remaining part with a convenient tool

 

• Place a keyring in your Coiler if you want to take it always with you.